Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY INFORMATION
Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
●This light fixture is designed to fit standard junction boxes as defined by the National Electrical
Code.
Consult a qualified electrician if you are not certain about the installation process. Always install
wiring connections in accordance with local code, ordinances and the National Electric Code.
NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver in
connected.
-Consult the dealer or an experienced radio/TV technician for help.
PREPARATION
Before beginning to assemble or install lighting fixture, make sure all parts are present. Compare
parts with package contents list and hardware contents list. If any part is missing or damaged, do
not attempt to assemble
the product.
●Estimated Assembly Time: 30 - 60 minutes (Installation time will vary depending on skill level
and existing wiring conditions. Estimated installation time assumes standard wall junction box and
supply wiring are already installed).
●Tools Required for Assembly (not included): Phillips screwdriver, flathead screwdriver, step ladder,
wrench or pliers, silicone caulking adhesive.
●NOTE: This fixture can only be installed on a wall.
●Helpful Items (not included): Wire cutters and/or wire strippers.
●It is recommended to install this fixture at a height of at least 6 ft. and not more than 20 ft.
3
Publicidad
