Publicidad
Idiomas disponibles
Idiomas disponibles
1600A014NP 08-18 GWS10-45DE.qxp_GWS 8/24/18 8:50 AM Page 13
DISC GRINDING WHEEL ASSEMBLY
Unplug tool from power source. Be sure that
wheel guard is in place for grinding. Place
BACKING FLANGE and GRINDING WHEEL
on the spindle. Thread on the lock nut and
tighten nut using the supplied lock nut wrench,
while holding the spindle lock in (Fig. 4).
TO REMOVE: Reverse procedure.
Not recommended for use with spin-on
wheels.
TYPE 27
GRINDING
WHEEL
ABRASIVE TYPE 41/1A AND 27A
WHEEL ASSEMBLY
Using the optional Type 41/1A wheel guard,
it is possible to perform limited cutting on
small stock such as metal tubes, piping or
rebar.
Do not attempt to cut large stock or sheets of
metal as this tool is not designed to be a
dedicated cutting tool.
cutting.
Unplug tool from power source. Be sure that
wheel guard is in place for cutting.
When using mounting wheels, thread
BACKING FLANGE onto spindle, then place
WHEEL on the spindle. Thread on the lock
nut and tighten ut using a lock nut wrench
provided with adapter kit, while holding the
spindle lock in (Fig. 5).
TO REMOVE: Reverse procedure.
TYPE 41/1A ABRASIVE
STRAIGHT GRINDING WHEELS
designed for straight/die grinding. This tool
is not designed for use with Type 41/1A
abrasive straight/die grinding wheels.
SPINDLE
BACKING
FLANGE
LOCK NUT
Always use Type 41/1A
protection
guard
Do not use Type 41/1A
abrasive
wheels
FIG. 4
SPINDLE
for
TYPE 41/1A
CUTTING WHEEL
-13-
TYPE 27
WHEEL
GUARD
BACKING
FLANGE
TYPE 27
GRINDING
WHEEL
LOCK NUT
FIG. 5
SPINDLE
TYPE 41/1A
WHEEL GUARD
BACKING
FLANGE
LOCK NUT
TYPE 27A
CUTOFF
WHEEL
Publicidad
