Munchkin MK0009-111 Manual Del Usuario página 7

How To Install
STEP 5: MOUNT YOUR GATE
1. Place the gate where you want to install it, then extend all 4 adjustment rods until they
reach the walls. Ensure that the ends of the adjustment rods are seated
inside the cups.
12
TOOLS NEEDED:
Wrench
2. Use the wrench to tighten the nuts on all 4 threaded
adjustment rods until the gate is secure. Tighten each
nut a little at a time, starting at the bottom of the
gate, then move to the upper hinge-side, and lastly
the upper handle side.
3. The nuts should be tightened until the handle latch
locks into frame.
PLEASE NOTE: DO NOT overextend
the adjustment rods. If the gate is more
than 2.5" (63.5mm) from the wall, you
must add an extension. See page 16
for additional extension configurations.
How To Install
2
3
1/16" (1.5mm)
<2.5" (<63.5mm) <2.5" (<63.5mm)
13