S.P.E. GREEN6 Manual Del Usuario página 16

User Manual
21) The possibility of the BMS acting directly on the battery charger
operation during cell balancing phases rules out, for any reason
whatsoever, that the battery charger is held directly responsible
should damage caused to the battery, or even a fire or an explosion,
be due to an error in the BMS software.
22) The faculty offered by the materials produced by S.P.E.
ELETTRONICA INDUSTRIALE to select different levels of voltage
for charging, is entrusted to the control and supervision of the end
user and S.P.E. ELETTRONICA INDUSTRIALE is not liable for any
consequences resulting from the selection of the incorrect level of
voltage. If in doubt, the user should ask a qualified professional for
clarification.
23) The battery charger tolerance thresholds, as far as levels of
over-voltage and overcharging are concerned, are used only for the
safeguarding of the systems of the same and have no safety
functions for the battery itself, the safety of which depends solely on
the BMS, even when the battery charger is connected to the battery,
whether the latter is being charged or not.
24) Should the client want to use the battery charger on a specific
on-board system and in general in any cases of special usage, it is
the client's
INDUSTRIALE, so that the latter can draw up any necessary
recommendations. In this case, the client must provide S.P.E.
ELETTRONICA INDUSTRIALE with all designs, diagrams and
descriptive
INDUSTRIALE cannot be held responsible for any damage resulting
from the use of the battery charger after opening it and/or modifying
it and/or inserting it into other systems.
25) Under
INDUSTRIALE be held responsible for the malfunctioning of the
batteries or the incineration/explosion of these, in so much as the
safety of the battery is the task of the BMS and not of the battery
charger.
16
responsibility
material necessary.
no circumstances
to inform
S.P.E.
can S.P.E.
S.P.E. ELETTRONICA
ELETTRONICA
ELETTRONICA
D00582-08