Publicidad
Idiomas disponibles
Idiomas disponibles
1. Unplug your unit, and remove tank.
2. Turn motor cover up by placing polisher in front of you,
incline the machine toward you pressing the motor cover down.
3. Place the brush on spindle and press down until it locks
into position (Fig. C)
4. Pads should be placed on top of scrubbing or polishing
brushes only. Place pad retainer in hole on pad and
press down to snap into position (Fig. D)
5. To remove pads, pull the pad retainers firmly out of place.
6. To remove brushes, pull them out firmly.
CAUTION: PLACE PADS ON SCRUBBING BRUSHES OR
POLISHING BRUSHES ONLY, NEVER ON CARPET BRUSHES.
HOW TO START YOUR RUG SHAMPOOER / FLOOR POLISHER
1. Pull the handle toward you (Fig. E) to the operating position.
2. Using switch box turn on the Shampooer/Polisher,
see chart bellow.
SPEED:
LOW/MEDIUM:
To scrub floors, shampoo carpets
HIGH:
To polish to a high gloss.
NOT ALL MODELS ARE THREE (3) SPEEDS.
HOW TO CLEAN TANK AND ACCESSORIES
STORAGE: ALL ACCESSORIES AND TANK SHOULD BE COMPLETELY DRY BEFORE STORING THEM.
REMOVE BRUSHES AND PADS FROM MACHINE FOR STORAGE.
Cord Storage: After use, unplug and coil the power cord around the cord wrap placed on the back of the machine.
BRUSHES
After each use, wash with lukewarm soapy water.
NEVER USE HOT WATER. Shake out excess water.
Stand bristles on paper towel to dry.
DO NOT FORCE DRY BY USING OVEN OR RADIATOR HEAT.
PADS
Pads should be washed with warm soapy water. Rinse
throughly in cold water. Stretch out to shape and allow
to dry on a flat surface.
TANK
Rinse thoroughly with warm water and allow to dry. (Fig. G)
NEVER STORE LIQUID IN TANK
Flush dispensing system by partially filling tank with
warm water and mounting it and dispensing the water into
a receptacle placed under the unit.
1. Vacuum carpet to remove any loose dirt.
2. Test color fastness of your carpet by cleaning a small area with
your shampooer / polisher following steps 5,6 and 7.
While damp, brush carpet in one direction and let dry. If your color
holds, you can proceed to shampoo the rest of your carpet
3.Pretreat spots and stains with a carpet spotter.
4. Remove all furniture from room, or protect as shown in figure (A).
5. Attach the SHAMPOO BRUSHES.
HOW TO INSTALL BRUSHES AND PADS
All manuals and user guides at all-guides.com
CARPET CARE
FIG. C
FIG. E
FIG. G
-7-
FIG. D
FIG. F
FIG. A
Publicidad
