Klarstein BOTELLA 120S Manual Del Usuario página 31

1 Install the wine refrigerator in a place where the door can be opened at the
maximum angle.
2 Use a small knife (2) to remove the decorative nails (1) on the opposite side (see
figure 1).
3 Use the hexagonal screwdriver (5) to loosen the screws (4) of the drop guard (3),
and then remove the drop guard (see figure 1).
4 Hold the door and use the hexagonal screwdriver (5) to unscrew the door shaft
core (6) from both ends of the door. Remove the door and set it aside (see figure 2).
5 Remove the upper and lower door hinges (7/8) with the hex screwdriver (5) and
install the door hinges on the opposite side (see figure 3 & 4).
6 Rotate the door 180° and install the door on the right side of the wine refrigerator
(see figure 5).
7 Finally, attach the decorative nails and the drop guard on the opposite side (see
figure 6).
EN
31