Stile CF0111 Guia De Instalacion página 13

INSTALLATION
MAKING THE ELECTRICAL CONNECTIONS
WARNING:
Verify the power has been disconnected to both
the room and the wall switch before making the
electrical connections. Failure to do so could
cause fire, electric shock, serious personal injury,
or death.
NOTICE:
When shipped, the electrical wires from the ceiling
fan offer enough length to accommodate only
the downrod included. If you intend to use an
extended-length downrod (not included), you will
need to purchase a wiring extension cable also.
See the Accessories section later in this manual
to determine the size extension cable needed to
fit your downrod, then visit the retailer where you
purchased this fan or call customer service to
purchase.
Connect the ceiling fan to the receiver:
 Connect the fan plugs at the end of the fan's electrical
wiring into their corresponding sockets on the receiver.
Connect the receiver to the 120V electrical supply wires:
 If your outlet box has a ground wire (green or bare cop-
per), connect it to the ground wire on the ceiling fan's
pivot ball. If there is no ground wire in your outlet box,
connect the ground wire on the pivot ball to the ground
wire on the mounting bracket assembly.
 Connect the white (neutral) supply wire to the white wire
on the receiver marked AC in N.
 Connect the black (hot) supply wire to the black wire on
the receiver marked AC in L.
NOTE: If your electrical box has both red and black hot
wires, only one of these will be needed. Choose the sup-
ply wire that matches the wall switch you want to use for
your ceiling fan. Use a wire cap and electrical tape to seal
off the other wire and tuck it back up into the box and
out of the way.
 Install a plastic wire nut over each connection to secure.
Reinforce with electrical tape as needed to make sure
no bare wire is visible at the wire nuts (except for a bare
ground wire, if present).
 Spread the wires apart so the green/yellow and white
wires go to one side and the black wire goes to the other,
then carefully tuck all the wire connections up into the
outlet box.
NOTE: Orient the wires so the wire nuts are facing up
and are not touching each other. This will help minimize
potential noise once the installation is complete.
MOUNTING
BRACKET
BLACK
BLACK
RECEIVER
RECEIVER
SOCKETS
For Canada installations, refer to the Canada
Installation Addendum and connect the support
cable to the eye bolt or anchor assembly now.
13 - English
CONDUCTOR
WHITE
FAN PLUGS
GROUND
GREEN/
YELLOW
GREEN/
YELLOW