Stile CF0111 Guia De Instalacion página 16

OPERATION
 Install the CR2032 button cell battery provided into the
remote control as shown.
UNLOCK
BATTERY COVER
BUTTON CELL
BATTERY
 Turn on the wall switch to provide power to the fan. For
approximately 1 minute after the switch is turned on, the
fan will search for the remote control. To pair the remote
to the fan, press and hold the remote's fan ( ) and light
( ) on/off buttons simultaneously for approximately 5
seconds.
NOTE: A total of 3 remotes can be paired to the fan.
Simply repeat the step above to pair each one.
BLADE
DIRECTION
BRIGHTER
DIMMER
 To turn the light on and off, press and release the light
on/off button ( ). Use the up ( ) and down ( ) arrows
to control the brightness of the light.
LOCK
REMOTE CONTROL
SPEED
UP
FAN ON/OFF
SPEED
DOWN
LIGHT ON/OFF
REMOTE
CONTROL
16 - English
NOTE: The brightness of the fan light can only be con-
trolled by the remote control. A wall-mounted dimmer
switch will not change the light's brightness.
 To turn the fan on and off, press and release the fan
on/off button ( ). Use the up ( ) and down ( ) arrows
to cycle through the fan speeds of Low, Medium, and Hi.
 To change the rotation direction of the ceiling fan blades,
allow the blades to come to a complete stop, then press
the blade direction button (
To mount the remote control holder:
 Remove the screw cover from the remote control holder.
 Install the remote control holder in the desired location
using the two mounting screws provided.
 Replace the screw cover to cover the screw heads.
WARNING:
Always dispose of used batteries properly, includ-
ing keeping them away from children. Even used
cells may cause injury.
MODEL NO: CFARC02
FCC ID: VMZCFARC02
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device
must accept any interference received, including interference
that may cause undesired operation.
NOTE: THE GRANTEE IS NOT RESPONSIBLE FOR ANY
CHANGES OR MODIFICATIONS NOT EXPRESSLY AP-
PROVED BY THE PARTY RESPONSIBLE FOR COMPLI-
ANCE. SUCH MODIFICATIONS COULD VOID THE USER'S
AUTHORITY TO OPERATE THE EQUIPMENT.
This device complies with Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including inter-
ference that may cause undesired operation of the device.
).
SCREW
COVER
REMOTE CONTROL
HOLDER
SCREWS