Publicidad
Idiomas disponibles
Idiomas disponibles
•
Do not use a propane cylinder with a damaged valve and any other worn out parts.
• Transport and store the empty gas cylinders carefully and properly.
• If you see, smell or hear the hiss of escaping gas from the propane cylinder: 1. Disconnect propane
gas cylinder, 2. Do not attempt to correct the problem yourself, 3. Get to your gas supplier and/or the
•
operating this appliance.
Maximum gas supply: 250 psi; Min. gas supply: 10 psi.
•
• This appliance is designed for use with a 16.40Z (1Lb) propane gas cylinder (disposable). The
cylinders of the U.S. Department of Transportation (DOT) or the National Standards of Canada, CAN/
CSA-B339, cylinders, Spheres and Tubes for Transportation of Dangerous Goods;and Commission,as
applicable.
• Cylinders must be stored outdoors in well-ventilated area out of the reach of children.
• Disconnected cylinders must have valve caps tightly installed and must not be stored in a building or
any other enclosed area.
• Do not light or use gas unit if lava rocks are wet. Ensure lava rocks are completely dry before
igniting.
• Pumice stones/lava rocks/LavaGlass
• During Ignition procedure, one should NEVER get his/her face close to and or above the burner. In
• Children should never operate this unit. Children must be supervised while near this unit.
•
inspected annually and cleaned regularly.
• Children and adults should be alerted to the hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
• Young children should be carefully supervised when they are in the area of the appliance.
•
near the appliance.
• Any guard or other protective device removed for servicing the appliance shall be replaced
prior to operating the appliance.
•
may be required as necessary. It is imperative that the control compartment, burners and
circulating airways of the appliance are kept clean.
•
The cylinder must be disconnected when the appliance is not in use.
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co., Inc.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, calls Bond
Manufacturing Co., Inc. at 1.866.771.2663.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned "OFF" before assembling. Do NOT attempt to assemble without proper tools.
could hit somebody's face or eyes during initial start of this
®
1-866-771-2663 | Page 3
Publicidad
