Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Safety Precautions
–
Use grill, as purchased, only with LP (propane) gas and
the regulator/valve assembly supplied. A conversion kit
must be purchased for use with natural gas.
–
Grill installation must conform with local codes, or in their
absence of local codes, with either the National Fuel Gas
Code, ANSI Z223.1/ NFPA 54, Natural Gas and Propane
Installation Code, CSA B149.1, or Propane Storage and
Handling Code, B149.2, or the Standard for Recreational
Vehicles, ANSI A 119.2/NFPA 1192, and CSA Z240 RV
Series, Recreational Vehicle Code, as applicable.
–
All electrical accessories (such as rotisserie) must be
electrically grounded in accordance with local codes, or
National Electrical Code, ANSI / NFPA 70 or Canadian
Electrical Code, CSA C22.1. Keep any electrical cords
and/or fuel supply hoses away from any hot surfaces.
–
This grill is safety certified for use in the United States
and/or Canada only. Do not modify for use in any other
location. Modification will result in a safety hazard.
–
The pressure regulator and hose assembly supplied must
be used and replacements must be those specified by
appliance manufacturer.
WARNING
Do not attempt to repair or alter the
hose/valve/regulator for any "assumed" defect. Any
modification to this assembly will void your warranty
and create the risk of a gas leak and fire. Use only
authorized replacement parts supplied by
manufacturer.
CAUTION
Using pots larger than 15 quarts in capacity could
exceed weight limit of the
side burner shelf,
resulting in failure
of grill cart
components.
USE AND CARE
DANGER
NEVER store a spare cylinder under or near the
appliance or in an enclosed area.
Never fill a cylinder beyond 80% full.
An over filled or improperly stored cylinder is a hazard
due to possible gas release from the safety relief valve.
If you see, smell or hear gas escaping, immediately get
away from the LP cylinder/appliance and call your fire
department.
This could cause an intense fire with risk of property
damage, serious injury or death.
LP Cylinder Removal, Transport and Storage
Turn OFF all control knobs and LP cylinder valve. Turn
·
coupling nut counterclockwise by hand only - do not use tools
to disconnect. Loosen cylinder screw beneath bottom shelf,
then lift LP cylinder up and out of cart. Install safety cap onto
LP cylinder valve. Always use cap and strap supplied with
valve. Failure to use safety cap as directed may result in
serious personal injury and/or property damage.
A disconnected LP cylinder in
·
storage or being transported
must have a safety cap installed
(as shown). Do not store an LP
cylinder in enclosed spaces such as a
carport, garage, porch, covered patio or
other building. Never leave an LP cylinder
inside a vehicle which may become overheated
by the sun.
Do not store an LP cylinder in an area where children play.
·
LP Cylinder Valve
Safety
Cap
Retainer Strap
3
Publicidad
