Electrical Safety; Functional Description - Makita ML104 Manual De Instrucciones

Linterna led inalámbrica
Ocultar thumbs Ver también para ML104:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

13. Do not incinerate the battery cartridge even if it is
severely damaged or is completely worn out. The
battery cartridge can explode in a fire.
14. Follow your local regulations relating to disposal of
battery.
15. The contained lithium-ion batteries are subject to the
Dangerous Goods Legislation requirements. For
commercial transports e.g. by third parties, forwarding
agents, special requirement on packaging and
labeling must be observed.
For preparation of the item being shipped, consulting
an expert for hazardous material is required. Please
also observe possibly more detailed national
regulations. Tape or mask off open contacts and pack
up the battery in such a manner that it cannot move
around in the packaging.

Electrical safety

1. Do not insert a nail, wire, etc. into USB power supply
port. Otherwise a circuit short may cause smoke and
fire.
2. Do not connect power source to USB port. Otherwise
there is risk of fire. The USB port is only intended for
charging lower voltage device. Always place the cover
onto the USB port when not charging the lower
voltage device.
CAUTION:
1. When the luminaire is not in use, always switch off
and remove the battery cartridge from the luminaire.
2. Do not store the luminaire and battery cartridge in
locations where the temperature may reach or exceed
50°C (122°F).
3. Do not give the luminaire a shock by dropping,
striking, etc.
4. Do not expose the light to eyes continuously. It may
hurt them.
5. Do not cover or clog the lit luminaire with cloth or
carton, etc. Covering or clogging it may cause a flame.
6. Do not disassemble the charger or battery cartridge;
take it to a qualified serviceman when service or repair
is required. Incorrect reassembly may result in a risk
of electric shock or fire.
7. Use the luminaires only with specifically designated
battery packs. Use of any other battery packs may
create a risk of injury and fire.
8. If operating time has become excessively shorter, stop
operating immediately. It may result in a risk of
overheating, possible burns and even an explosion.
9. Do not use a damaged battery.
10. Charge the battery cartridge before completely
discharged. Always stop luminaire operation and
charge the battery cartridge when you notice less
luminaire power.
11. Never recharge a fully charged battery cartridge.
Overcharging shortens the battery service life.
12. If any problem develops, consult your nearest Makita
Service Center or dealer. To maintain product safety
and reliability, repairs, maintenance or adjustment
should be carried out by Makita Authorized Service
Center.
13. Charge the battery cartridge if you do not use it for a
long period (more than six months).
4
FCC Cautions to the user
The changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
The equipment has been tested and found to comply with
the limits for a Class B Digital Device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful
interference to radio communication.
However, there is no grantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
For United States:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
CAN ICES-5(B)/NMB-5(B)
SAVE THESE INSTRUCTIONS.
CAUTION: Only use genuine Makita lithium-ion
batteries. Use of non-genuine Makita batteries, or
batteries that have been altered, may result in the battery
bursting causing fires, personal injury and damage.

FUNCTIONAL DESCRIPTION

Installing or removing the battery
cartridge (Fig. 1)
CAUTION:
• Always switch off the luminaire before installing or
removing of the battery cartridge.
• Hold the luminaire and the battery cartridge firmly
when installing or removing battery cartridge.
Failure to hold the luminaire and the battery cartridge
firmly may cause them to slip off your hands and result
in damage to the luminaire and battery cartridge and a
personal injury.
To remove the battery cartridge, slide it from the luminaire
while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip it
into place. Insert it all the way until it locks in place with a
little click. If you can see the red indicator on the upper
side of the button, it is not locked completely.

Publicidad

Tabla de contenido
loading

Tabla de contenido