Publicidad
Idiomas disponibles
Idiomas disponibles
Connect Spray
4
Wand to Spray
Gun
Thread the spray wand into
the end of the spray gun.
Release Air from
7
System
Release all air from
pump and high pressure
hose by depressing
trigger until a steady
stream of water is present.
Approximately 30 seconds.
30 S
Verify the Choke Pin
10
is Pulled Out to the
CLOSED Position
The Choke Pin has been
preset by the factory to be
in the CLOSED Position.
See label #10 on unit.
WARNING: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using this product.
Connect QC
5
Nozzles to Spray
Wand
Pull quick connect
coupler back and insert
nozzle. Release quick
connect coupler and
twist nozzle to make sure
it is secure in coupler.
Verify the Fuel
8
Valve is turned to
the OPEN
Position
The Fuel Valve has been
preset by the factory to
be in the OPEN position.
See label #8 on unit.
Pull the
11
Recoil Starter
Grip
Pull the recoil
starter grip to start
the engine.
See label #11 on unit.
9 - ENG
Turn Water
6
Faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
Verify the Engine
9
Switch is turned
to the ON
Position
See label #9 on unit.
Push the
12
Choke Pin to
the OPEN
Position
Gradually move
the Choke Pin to
the OPEN Position
after engine starts.
See label #12 on unit.
Publicidad
