Bimar VP431 Folleto De Instrucciones página 13

Attention: always unplug the appliance before you assemble.
ASSEMBLY
Attention: the fan can be used only when completely and correctly assembled, that is complete with its base
and protection grid.
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power cord
is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person with
similar qualifications, in order to avoid any risk.
If in doubt, have the appliance checked or assembled by a qualified professional person. For assembly, refer
to figure.
Stand
A. Set the column (13) in place on the base (2) and secure it using the "L" screw with washer (1).
B. Lengthen the adjustable pole (6) until the height desired and lock it by tightening the pole attachment
ring nut (5). At the end of the operation, check that the column and base are firmly coupled.
Fan
C. Unscrew the ring nuts: fan fixing (3) and rear grid (14).
D. Insert the rear grille (11) in the motor
housing, so that the handle appears at the
top (as figure), and position it so that the pins
fit in their corresponding holes and lock it
with the ring nut provided (14).
E. Insert the propeller (12) on the motor shaft (4), so that the slot matches the
spline. Lock using the ring nut (3), (turning it counter clockwise to tighten).
F. Couple the front grille (10) to the rear one (11) locking it with the closing
hooks. For safety reasons, you must make sure that it is attached by using
the screws and nuts provided (9), which are to be used in the holes in the
edge of the grilles (the holes for the screw must be in the lower part).
At the end of the operation, check that the protective grills are firmly
coupled and attached to the motor.
G. Attach the fan body to the stand by inserting the lower hole on the
adjustable pole of the stand and lock it by tightening the stand attachment
screw (7).
13/44