Publicidad
Idiomas disponibles
Idiomas disponibles
®
Deactivating the Bluetooth
Interface
®
The Bluetooth
connection is deactivated in the basic settings.
®
To deactivate the Bluetooth
signal, press button 11 [–] or
switch off the measuring tool.
Working Advice
Further information can be found on the Bosch product
page.
The measuring tool is equipped with a radio interface.
Local operating restrictions, e.g. in airplanes or hospitals,
are to be observed.
General Information
The reception lens 18, the laser beam output 20 and the digital
viewfinder 19 must not be covered during measurement.
The measuring tool must not be moved while taking a
measurement. Therefore, place the measuring tool, as far as
this is possible, against or on a firm stop or supporting surface.
Influence Effects on the Measuring Range
The measuring range depends on the lighting conditions
and the reflective properties of the target surface. For better
visibility of the laser beam in strong extraneous light, use the
integrated digital viewfinder 19, the laser viewing glasses 26
(accessory) and the laser target plate 25 (accessory) or shade
the target area.
Influence Effects on the Measuring Result
Due to physical effects, faulty measurements cannot be
excluded when measuring on different surfaces. Included here
are:
– Transparent surfaces (e.g., glass, water),
– Reflecting surfaces (e.g., polished metal, glass),
– Porous surfaces (e.g. insulation materials),
– Structured surfaces (e.g., roughcast, natural stone).
If required, use the laser target plate 25 (accessory) on these
surfaces.
Furthermore, faulty measurements are also possible when
sighting inclined target surfaces.
35
2610049010 04-18 GLM400C.indd 35
4/6/18 8:20 AM
Publicidad
