Publicidad
Idiomas disponibles
Idiomas disponibles
General Instructions
Note: When tightening no.17 and
no.18, make sure that both no.16's
are located at the same height
above sink level. Tighten no.17 and
no.18 before tightening no.19 and
no.20. Verify dimension from deck
to top of no.16. Adjust no.17 and
no.20 if required.
15. Tighten second (bottom) no.11
against no.9 with a wrench.
16. Tighten no.13 on both no.16's
with a wrench.
Valve Assembly:
17. Replace no.21 and no.22 on both
sides of no.16 and tighten bonnets
suffi ciently by hand to position
valves.
21/22
16
sink
18. Remove packing nut/locknut as-
sembly from both no.21 and no.22.
19. Slip no.23 over each no.21,22.
Make sure washer is in place.
20. Packing nut and locknut should
be loosely assembled before replac-
ing into no.21,22. Hand-tighten
locknuts only against no.23. Do not
use a wrench.
packing nut
locknut
23
bonnet
packing
21. Tighten packing nut down
against locknut using two wrenches.
Hold locknut while rotating packing
nut.
22. Attach no.24 to no.21,22 and
screw in no.28. Place no.27 in the
appropriate no.24.
24, 27, 28
23
Note: It may become necessary
to tighten bonnets and packing
nuts to stop leakage from outlet
or around spindle assembly
23. Wrench tighten all parts if neces-
sary.
24. Turn on water supply and check
for leaks.
6
Publicidad
