to ensure the alternator is rotating with the
engine running. If the belts are slipping or
broken, replace the belts and retest.
Check the connections from the alternator to the battery. If the connection is
loose or heavily corroded, clean or replace the cable and retest. If the belts
and connections are in good working condition, replace the alternator.
CHARGING SYSTEM NORMAL WHEN TEST
WITH ACCESSORY LOADS
The system is showing normal output from the
alternator. No problem detected.
10. Press «ENTER» when charging system test is
completed. Turn all accessory loads and
engine off. Press «ENTER» to read the system
test results.
11. Press "ENTER" to press result or not.
IN-VEHICLE TEST
This is a combination test of both battery test & system test. Please refer to
above testing procedures or follow the instructions on the display of the tester.
TEST OVER. TURN
ALT. LOAD VOLTS
RIPPLE VOLTAGE
CRANKING VOLTAGE
14
ALT. LOAD VOLTS
xx.xx V NORMAL
OFF LOADS &
ENGINE
xx.xx V NORMAL
xx.xx V NORMAL
xx.xx V NORMAL
ALT. IDLE VOLTS
xx.xx V NORMAL
PRINT RESULT?
YES/NO