Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE STACK BRACKET KIT
1. Remove the Dryer
Leveling Legs
A. Carefully lay the dryer on its side.
Use the packing material so you
don't scratch the finish on the
dryer.
B. Use an open-end wrench or pliers
to remove the dryer leveling legs.
Back out and remove
all 4 leveling legs
2. Install Rubber Pads
to Dryer Base
Locate the 4 rubber pads in the
parts package. Remove the adhesive
backing and firmly place over on the
bracket where you removed the
leveling legs.
3. Install Bracket
to Dryer
A. Align the holes in the left bracket
with the holes in the bottom left
corner of the dryer. Use a Phillips
screwdriver to install the 2 #12 x 1"
tapping screws.
B. Repeat the above step with the
right bracket on the bottom right
corner of the dryer.
C. Set the dryer upright.
NOTE: Make sure to set the dryer
on a piece of packing material so
the brackets that are attached to the
bottom of the dryer do not damage
the floor.
ge.com
21
Publicidad
