Publicidad
Installation
Notes
• Before finally installing the unit, connect the
wiring temporarily, making sure it is all con-
nected up properly, and the unit and the sys-
tem work properly.
• Use only the parts included with the unit to
ensure proper installation. The use of unau-
thorized parts can cause malfunctions.
• Consult with your nearest dealer if installation
requires the drilling of holes or other modifi-
cations of the vehicle.
• Install the unit where it does not get in the
driver's way and cannot injure the passenger
if there is a sudden stop, like an emergency
stop.
• The semiconductor laser will be damaged if it
overheats, so don't install the unit anywhere
hot — for instance, near a heater outlet.
DIN Front/Rear-mount
This unit can be properly installed either from "Front" (conventional DIN Front-mount) or "Rear"
(DIN Rear-mount installation, utilizing threaded screw holes at the sides of unit chassis). For
details, refer to the following illustrated installation methods.
• If installation angle exceeds 30° from horizon-
tal, the unit might not give its optimum perfor-
mance.
• The cords must not cover up the area shown
in the figure below. This is necessary to allow
the amplifires to radiate freely.
Do not close this area.
11
En
Publicidad
