NAD T955 Manual Del Usuario página 7

INSTALLATION PRECAUTIONS
WARNING - To reduce the risk of fire or electrical shock, do not
expose the amplifier to rain or moisture.
CAUTION - For units factory-set at 115 volts AC match the wide
blade of the power plug to the wide slot of the power outlet, to
prevent electrical shock. Be sure the plug is completely inserted into
the receptacle.
Turn off all the components in the system whenever connecting or
disconnecting any audio signal wiring. Once all signal connections
have been completed, turn down all the system's main volume control
before turning the system components on. Then increase the volume
control setting carefully to avoid damage to the system components.
NOTES ON INSTALLATION LOCATION
Read and follow all the safety instructions on the first page of
this manual. To prevent a fire or shock hazard, do not place the
amplifier where it will be exposed to any water or moisture. If liquid
accidentally gets into the amplifier, immediately unplug the AC power
cord. Do not operate the amplifier again until it has been examined
by a service technician.
The amplifier generates a moderate amount of heat, requiring
ventilation. Do not obstruct the air outlet grilles on the top or bottom
covers. There should be at least 3 inches (7.5 cm) of clearance above
the amplifier and 1 inch (2.5 cm) to the sides. Do not place the
amplifier in an enclosed area, such as in a bookcase or in a cabinet,
unless it is very well ventilated. Be sure there is adequate room behind
the amplifier for signal input and speaker output connections. If you
want to locate the amplifier on a carpeted floor, place a board under
it in order to prevent it from sinking into the carpet, blocking the
air inlets on the bottom. Do not place the amplifier where it will be
exposed to direct sun light for prolonged periods of time.
This unit may be installed on any sturdy, level surface.
T955 ML - e.indd 7
NOTES: The amplifier's weight must always rest on its bottom feet.
Never put the amp down on its rear panel, with its front panel
facing up. Doing so risks damage to the input/output connectors.
The power transformer in the T955 generates a magnetic hum
field of moderate strength. Turntables (especially those with a
moving-coil pickup cartridge) should not be located near the
amplifier. Magnetic media, such as audio or video tapes and
computer diskettes, should not be stored near the amplifier.
TRANSPORTATION
Transport - Transport the amplifier in both inner and outer shipping
containers. Do not transport the apparatus using one shipping
container; to do so may result in damage to either the apparatus or
personnel.
SAVE ALL THE PACKAGING
Please save both boxes and all of the packaging in which your
T955 arrived. Should you move or otherwise need to transport your
amplifier, this is by far the safest set of containers in which to do so.
We've seen too many otherwise perfect components damaged in
transit for lack of proper shipping cartons, so please: Save both inner
and outer boxes!\
REAR PANEL CONNECTIONS/CONTROLS
1. IEC POWER SOCKET
Connect to the supplied IEC-standard removable AC power cord
before connecting the AC power cord to the wall socket.
NOTE: Before connecting the AC-power cord to a live wall socket
insure that all inputs/outputs are connected first. Always disconnect
the AC power cord plug from the live wall socket first, before
disconnecting any cable from the T955 amplifier. If you must use
an extension cord, select a heavy-duty cord of the type used for
large electrical appliances, such as an air conditioner AC-extension
cord (16 AWG). We strongly recommend that you not connect
the amplifier's mains cable to the accessory AC outlets on a
preamplifier. Such convenience outlets are not designed to supply
the high-power levels that the NAD T955 amplifier requires.
7
5/16/06 4:50:22 PM