Publicidad
Idiomas disponibles
Idiomas disponibles
To install the accessory (Fig .6)
a. Make sure that the ON/OFF switch is in the
OFF position and remove the battery pack.
b. Turn the clamping lever counterclockwise
about 140° until an audible "click" signals
that the lever has been fully engaged to
unlock the clamp mechanism (Fig.6a).
c. Rotate the locking rod 90° clockwise, and
then pull out the locking rod (Fig.6b).
d. Ensure that the locking rod and the
drive shaft are clean before installing the
accessory.
e. Position the accessory on the drive shaft,
making sure that all the grooves on the
accessory align with the ribs on the drive
shaft (Fig.6c).
f. Insert the locking rod into the drive shaft,
then press the locking rod and rotate it 90°
counterclockwise so that it is secured in the
drive shaft (Fig.6c).
g. Return the clamping lever to its original
positon. An audible "click" will signal that
the lever has been fully engaged to lock the
clamping mechanism. After hearing the click,
continue to turn the lever until it returns to its
original position (Fig.6c).
NOTICE: Attach the accessory in the desired
orientation for the task at hand. The shaft is
configured so that the application accessory
can be installed around the tool in 30°
increments (Fig.7) for most accessories.
WARNING
blade, rigid scraper blade, or carbide grout-
removal blade so that they face backwards, as
attachment in this position may cause serious
injury.,
WARNING
the lock pattern of accessories fit each
other. Misalignment can lead to unstable
attachment, causing personal injury.
WARNING
blade, rigid scraper blade or carbide grout-
removal blade so that they face backwards, as
operation in this position may cause serious
injury.
CAUTION
body to guard against bruising when locking the clamping lever. Do not place your hands or
fingers between the locking rod and drive shaft.
14
Do not attach the plunge-
cut blade, flush circular
Make sure that the ribs of
the tool drive shaft and
Do not attach the plunge-
cut blade, flush circular
To avoid pinching skin, hold the clamping lever firmly when fastening an
accessory. Do not place hands or fingers between the lever and the tool
Fig.6a
Fig.6b
Fig.6c
Fig.7
-30
o
-60
o
-90
o
140
90
0
o
30
o
60
o
o
o
90
o
Publicidad
