HQ-Power HQLP10032 Manual Del Usuario página 9

6.5 DMX Mode
The DMX mode allows you to control the device with any universal DMX controller.

All DMX-controlled devices need a digital start address so that the correct device
responds to the signals. This digital start address is the channel number from which
the device starts to "listen" to the DMX controller. The same starting address can be
used for a whole group of devices or an individual address can be set for every
device.

When all devices have the same address, all the units will "listen" to the control
signal on one particular channel. In other words: changing the settings of one
channel will affect all devices simultaneously. If you set individual addresses, each
device will "listen" to a separate channel number. Changing the settings of one
channel will only affect the device in question.
DMX Channel Values
Refer to page 3 of this manual.
6.6 Remote Control
Black Out
Press this button to black out the current active mode. Press again to return.
Auto
1. Press <AUTO>.
2. Press <+> or <-> to choose the different programmes.
Sound
1. Press <SOUND>.
2. Press <+> or <-> to choose the different programmes.
Strobe
1. Press <STROBE>.
2. Press <+> or <-> to choose the different programmes.
Speed
1. Press <SPEED>.
2. Press <+> or <-> to adjust the programme speed.
Sensitivity
1. Press <SENSITIVITY>.
2. Press <+> or <-> to adjust the microphone sensitivity.
DMX/%
Allows you to activate/de-activate the DMX mode.
Manual
1. Press <MANUAL>.
2. Press <R>, <G> <B> or <UV> to select your colour.
3. Press <+> or <-> to select the static colours.
Fade
Press <FADE> to enable or disable the fader.
1-9
Press <1> to <9> to adjust the colour intensity.
V. 02 – 15/06/2018
HQLP10032
9 ©Velleman nv