Publicidad
Idiomas disponibles
Idiomas disponibles
012582
To turn on the lamp status, press the button
seconds. To turn off the lamp status, press the button
for few seconds again.
With the lamp status ON, pull the switch trigger to turn on
the lamp. To turn off, release it. The lamp goes out
approximately 10 seconds after releasing the switch
trigger.
With the lamp status OFF, the lamp will not turn on even if
the trigger is pulled.
NOTE:
To confirm the lamp status, pull the trigger. When
•
the lamp lights up by pulling the switch trigger, the
lamp status is ON. When the lamp does not come
on, the lamp status is OFF.
While pulling the switch trigger, the lamp status
•
cannot be changed.
For approximately 10 seconds after releasing the
•
switch trigger, the lamp status can be changed.
Reversing switch action
A
1
012576
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
side for clockwise rotation or from the B side for
counterclockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When not operating the tool, always set the
•
reversing switch lever to the neutral position.
1. Button
1
for few
1. Reversing
switch lever
B
Changing the impact force
2
3
4
5
1. Changed in four steps
2. Hard
3. Medium
4. Soft
5. T mode
6. Button
012609
6
1
6
Publicidad
