Samsung SW-212 Guia Del Usuario página 4

01.SW-212-eng 12/4/00 10:11 AM
Your CD-R/RW Drive
5
1 2 3
1. Connector for stereo headphones with a 3.6 mm stereo mini-jack
2. Headphone volume control
3. Indicator light (when it is green, a disc is being read or recorded)
4. Disc compartment (the compartment opens and closes
automatically when you press the Eject button)
5. Emergency eject hole (if the compartment does not open when
you press the Eject button, power off the computer, insert a pin or
unfolded paper clip in the hole and push firmly)
6. Eject button
1 2 3
1. Two-pin digital audio output terminal for use with a sound or
MPEG card supporting digital audio features
2. Four-pin sound output terminal for use with a sound card (refer to
the sound card documentation for further details)
3. Master/slave select terminal
4. Forty-pin host IDE interface connector
5. Four-pin power terminal
Page 4
6
4
4 5
4
Upgrading the Firmware Flash Memory
The product firmware can be upgraded by downloading the updated file from the
following Web site:
http://www.samsungelectronics.com
System Requirements
Before you install the CD-R/RW drive, we strongly recommend that you
check that your setup meets the system requirements listed below.
Item Description
Computer Intel Pentium II (or higher), 32 MB of RAM (or higher)
with an IDE interface
Disk space 700 MB minimum
Windows version Windows 95 / 98 OSR2 / 2000 / ME or Windows NT 4.0
(or higher)
Installing the CD-R/RW Drive
To install your CD-R/RW drive in the PC, proceed as follows.
1
Make sure that the PC is powered off and disconnected from any power source.
2
If necessary, attach a horizontal bracket to both sides of
the drive.
Use of the brackets depends on your computer
model; you can purchase these accessories
separately from your computer dealer.
3
Remove the cover from a free expansion slot and install
the CD-R/RW drive, as shown in the illustration.
If you have no free expansion slot, install the drive in
place of the diskette drive.
CD-R/RW drive
5