Mitsubishi Electric NTXWPH06A112A Serie Manual De Instrucciones página 5

P
REPARATION BEFORE OPERATION
Changing temperature units (°F→°C)
Unit is preset with °F.
1.
Press RESET while
the temperature but-
tons are pressed.
• Press RESET gently using a thin instrument.
• To change temperature unit from °C to °F, press RESET.
Setting the installation position
Be sure to set the remote controller in accordance with the installed position of
the indoor unit.
Installation position:
Left: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the left
Center: Distance to objects (wall, cabinet, etc.) is more than 19-11/16 in. (50
cm) to the left and right
Right: Distance to objects (wall, cabinet, etc.) is less than 19-11/16 in. (50 cm)
to the right
(Left) (Center) (Right)
Area Left
Remote controller
display
1
Hold down on the remote controller for 2 sec-
onds to enter the position setting mode.
2
Select the target installation position by pressing
(Each press of the
order:)
(Center) (Right)
3
Press to complete the position setting.
Note:
The installation position can be set only when all the following conditions are met:
• The remote controller is powered off.
• Weekly timer is not set.
• Weekly timer is not being edited.
Center Right
displays the positions in
(Left)
En-4
.