SNOWJOE sunjoe SPX3501 Manual Del Operador página 10

6. Make sure the safety lock is down and in its original
position (Fig. 12), then press the trigger for a few seconds
until water flow is steady. This will allow air to escape and
discharge any residual pressure in the hose.
Fig. 12
7. Turn the ON/OFF switch to the ON (I) position to start the
pressure washer (Fig. 13).
Fig. 13
ON/OFF switch
8. When re-starting the motor, always keep the trigger
pressed.
NOTE: The motor only runs when the trigger is operated
and shuts off when the trigger is released.
Using Nozzles
Before beginning any cleaning task, determine the best nozzle
for the job. Each of the nozzles has a different spray pattern.
The nozzle patterns are 40˚ (for gentle cleaning), 25˚ (for all-
purpose cleaning), 15˚ (for tough jobs), 0˚ (for spot cleaning
or hard-to-reach areas) and the Soap nozzle (for detergent
application).
m
CAUTION!
NEVER change nozzles without locking the
safety lock on the trigger handle.
m
subject to misuse. The jet must not be directed at persons,
pets, live electrical equipment, or the appliance itself.
This electric pressure washer is equipped with five (5) Quick-
Connect nozzles that easily snap onto the Quick-Connect
Safety lock
collar of the spray wand.
To connect a nozzle to the spray wand:
Slot
Trigger
To disconnect a nozzle from the spray wand once the cleaning
job is complete:
m
the trigger is engaged. Doing so could result in damage to the
pressure washer or injury to the user.
10
WARNING!
High-pressure jets can be dangerous if
1. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
2. Engage the safety lock on the trigger handle by pushing
up on the safety lock until it clicks into the slot (Fig. 14).
Fig. 14
3. Snap the desired nozzle onto the Quick-Connect collar
until it clicks into place (Fig. 15).
Spray wand quick-
Fig. 15
connect collar
4. Turn off the pressure washer and shut off the water supply.
Pull the trigger to release water pressure.
5. Engage the safety lock on the trigger handle by pushing
up on the safety lock until it clicks into the slot (Fig. 14).
6. Remove the nozzle by placing your hand over the nozzle
while pulling back on the Quick-Connect collar.
WARNING!
Do not make changes to the nozzle while
Slot
Safety lock
Nozzle
"Click"