Aetertek AT-216D Manual Del Propietário página 5

Quick Start
6
Step 6:
Match the receiver and transmitter. First, turn
the transmitter on by pressing shock, beep or vibrate
button. Choose a dog mode (Dog1, dog2 or dog3) by
pressing the dog switch button on the left side. For the
first receiver, choose dog 1 mode and quickly press one of
the three buttons in the front, and the first receiver will
be connected with the transmitter. Meanwhile, the red
light goes off and the blue light starts flashing. If you have
another receiver, turn it on, choose dog 2 mode, press any
function buttons, and the second receiver will be paired.
For third receiver, please use dog 3 mode.You can train
different dogs separately in different dog systems.
7
-03-
Press down Shock,
Beep or Vibrate button,
receiver will be synced
with transmitter.
Step 7:
Check the button function. Push the beep
button, the receiver will produce beeping sound and
similarly, push the vibrate button, it will cause vibration.
Cap the shock test kit on the metal prongs, push the shock
button. If the bulb lights up, the shock function is ok.
Tip 3:After 3 minutes of inactivity, transmitter will go into sleep mode.
You can wake it up by pressing any function keys.
8
Step 8:
Adjust the intensity of the shock function by rotat-
ing the thumbwheel. 7 shock levels are available.
Tip 4: The duration for pressing the vibrate, beep or shock button will lead
to difference on the length of the vibration , beep or shock time.
Step 9:
Start to train the dogs.Put the collar into the rece-
iver and wear the receiver around dog's neck. Remember to
leave one finger place between the collar and the neck, and
then you can train the dogs.
7
0
7 0