3
4
2
6
TECHNICAL DATA
BC615
VOLTAGE-FREQUENCY
POWER
CURRENT
WATER PROTECTION
MAX FLOW
INLET AND OUTLET DIAMETER
MAX HEIGHT
NO LOAD SPEED
POWER CONSUMPTION
MAX WATER TEMPERATURE
DUTY CYCLE (max. 6 hours)
WEIGHT
BC620
VOLTAGE-FREQUENCY
POWER
CURRENT
WATER PROTECTION
MAX FLOW
INLET AND OUTLET DIAMETER
MAX HEIGHT
NO LOAD SPEED
POWER CONSUMPTION
MAX WATER TEMPERATURE
DUTY CYCLE (max. 6 hours)
WEIGHT
ELECTRICAL CONNECTION
This equipment requires a 127 V electrical instal-
lation made by a qualified electrician.
127 V
Black
Yellow & Green
12
1
127 V ~ 60 Hz
1-1/2 HP (1 100 W)
12,2 A
IPX4
146 L/min
1-1/4" y 1" NPT
37 m
3 450 r/min
1,7 kWh
35°C
50 min x 20 min
16,6 kg (36,6 lb)
127 V ~ 60 Hz
2 HP (1500 W)
16,4 A
IPX4
152 L/min
1-1/4" y 1" NPT
42 m
3 450 r/min
2,3 kWh
35°C
50 min x 20 min
22,5 kg (49,6 lb)
~
Yellow
White
Make sure that the connections are suitable for
the power consumption of the equipment.
Overload
Code
protector
BC615
17Am165 ºC
5
BC620
OPERATION INSTRUCTIONS
IMPORTANT: These This pump is designed to
suck water at a height of up to 6 meters at sea
level, this condition decreases as the height of
the city or workplace increases.
- For best results, install your water pump as
close as possible to the water mirror, the water
mirror should be at least 20 inches above the
foot valve. Calculate correctly the demand of
your system and the correct diameter of the
pipes.
- If your motor pump is going to be set at a fixed
place, attach it firmly to the floor (use clamps,
expansive raw plugs, etc.)
always sure that it will not be moving for the
vibration.
The pump should be installed in a dry, properly
ventilated location at an ambient temperature
not to exceed 40 ° C (104 ° F)
NEVER ALLOW THAT YOUR MOTOR GETS
WET, USE PROTECTION COVER IF OUTDOORS.
AVOID COVERING THE MOTOR OF YOUR
MOTOR PUMP WITH PLASTIC THAT PREVENT
THE CIRCULATION OF AIR THROUGH IT SO THAT
IT COOLS DOWN. PLACE YOUR MOTOR PUMP
AT A VENTILATED PLACE.
Capacitor (1)
(3)
250V 70uF
N/A
250V 100uF
Otherwise, make
Motor
1-1/2 HP
2 HP