NeuLog NUL-206 Guia Del Usuario página 19

Sensor offset
Although the NeuLog pH sensor does not need to be
calibrated prior to each use, it is recommended to offset
its probe.
Materials needed:
pH 7 Buffer Solution (for qualitative measurements,
distilled or even tap water can be used instead)
Procedure:
1. Connect the pH sensor to a voltage source (USB-200
or BAT-200).
2. Remove the pH sensor probe's tip from the plastic
storage solution bottle.
3. Rinse the pH sensor's tip with distilled water.
4. Insert the pH sensor's tip into a pH 7 buffer; if no
buffer is available, you can use tap water instead
(although it is not as accurate).
5. Press and hold the pH sensor's push button for 3
seconds.
V2018.01
19
Home
English