Glacier bay HD833CX-0027D Guía De Instalación Y Cuidado página 8

Idiomas disponibles

Installation (continued)

Installing the tub and shower

outlet connections

NOTE: Do not use PEX or CPVC between the valve body (D)

and tub spout (K).

□

Wrap thread sealant tape around the pipe

threads in a clockwise direction, as shown.

□

Connect the shower (1) and tub outlet pipes (2)

to the valve body (D). Connect the pipe elbows

(3) (not included) to the ends of both pipes,

and tighten with a wrench.

NOTE: For shower-only installation, wrap thread sealant

tape around the threads of the plug (J), and insert it into

the bottom outlet (4).

Shower

Tub

Flushing the water outlets and

checking for leaks

□

For tub and shower combinations, turn on the

hot and cold water supply lines, allowing water

to ow from the tub spout outlet (1) until all

debris is cleared from the line. Check all

connections for leaks.

□

For shower only installations, turn on the hot

and cold water supply lines, allowing water

to ow from the shower outlet (2) until all

debris is cleared from the line. Pressure must

be approximately equal on both hot and cold

sides for the valve to function properly. Check

all connections for leaks.