Descargar Imprimir esta página

Makita DC24WA Manual De Instrucciones página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
ENGLISH
CAUTION:
1. SAVE THESE INSTRUCTIONS – This manual contains important safety and operating instructions for battery charger.
2. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using
battery.
3. CAUTION – To reduce risk of injury, charge only MAKITA rechargeable batteries. Other types of batteries may burst causing personal
injury and damage.
4. Non-rechargeable batteries cannot be charged with this battery charger.
5. Use a power source with the voltage specified on the nameplate of the charger.
6. Do not charge the battery cartridge in presence of flammable liquids or gases.
7. Do not expose charger to rain or snow.
8. Never carry charger by cord or yank it to disconnect from receptacle.
9. After charging or before attempting any maintenance or cleaning, unplug the charger from the power source. Pull by plug rather than
cord whenever disconnecting charger.
10. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.
11. Do not operate charger with damaged cord or plug — replace them immediately.
12. Do not operate or disassemble charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a
qualified serviceman. Incorrect use or reassembly may result in a risk of electric shock or fire.
13. The battery charger is not intended for use by young children or infirm persons without supervision.
14. Young children should be supervised to ensure that they do not play with the battery charger.
15. Do not charge battery cartridge when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F).
16. Do not attempt to use a step-up transformer, an engine generator or DC power receptacle.
17. Do not allow anything to cover or clog the charger vents.
Charging
1. Plug the battery charger into the proper AC voltage source. Two charging lights will flash in green color repeatedly.
2. Insert the battery cartridge into charger until it stops adjusting to the guide of charger. Terminal cover of charger can be opened with
inserting and closed with pulling out the battery cartridge.
3. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging
light will keep lighting up lit steadily during charging.
One red charging light indicates charged condition in 0 – 80% and two red ones indicates 80 – 100%.
4. With finish of charge, the charging lights will change from two red ones to two green ones.
5. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its "trickle charge
(maintenance charge)" mode which will last approximately 24 hours.
6. After charging, unplug the charger from the power source.
Refer to the table for the charging time below.
Voltage
9.6 V
Number of cells
8
B9017A
BH9020/A
Ni-MH Battery
cartridge
BH9033/A
Number of cells
Li-ion Battery
cartridge
*1
(Note)
... 24 V batteries can be charged with the charger DC24SC or DC24WA only.
NOTE:
• The battery charger is for charging Makita-battery cartridge. Never use it for other purposes or for other manufacturer's batteries.
• When you charge a battery cartridge which is new or has not been used for a long period of time, it may not accept a full charge until
after discharging it completely and recharging a couple of times.
• If you charge a battery cartridge from a just-operated tool or battery cartridge which has been left in a location exposed to direct sunlight
for a long time, the charging light may flash in red color. If this occurs, wait for a while. Charging will begin after the battery cartridge is
cooled by the cooling fan installed in the charger (DC14SC, DC18SC and DC24SC only). When the temperature on battery is more than
approx. 70°C, two charging lights may flash in red color, and when approx. 50°C – 70°C, one charging light in red color.
• If the charging light flashes alternately in green and red color, charging is not possible. The terminals on the charger or battery cartridge
are clogged with dust or the battery cartridge is worn out or damaged.
12 V
14.4 V
18 V
10
12
BH1220/C
BH1420
BH1427
BH1233/C
BH1433
8
10
BL1430
BL1830
*1
24 V
Capacity
(Ah)
20
DC14SC
30
1.7
B2417
30
2.0
BH2420
2.7
40
B2430
3.0
50
3.3
BH2433
45
3.0
Charging time (Minutes)
DC18SC
DC24SC
DC24WA
30
20
30
30
20
30
40
25
50
50
30
50
45
30
45
35
40
55
40
55
55
90
70
90
5

Publicidad

loading

Este manual también es adecuado para:

Dc18scDc24scDc14sc