Forch 5331 1 18 3 Manual Original página 20

– Turn the application tool to the required chisel
position.
– Turn the impact/mode selector switch (7) to the
"chiselling" position. With this, the tool holder is
locked.
– Set the rotational direction for chiselling to clock-
wise.
Practical Advice
English
Setting the drilling depth (see figure D)
You can use the depth stop (15) to set the re-
quired drilling depth X.
– Press the button for depth stop adjustment (5)
and insert the depth stop into the auxiliary
handle (14).
The fluting on the depth stop (15) must face
downwards.
– Insert the SDS-plus application tool into the
SDS-plus tool holder (2) to the stop. Otherwise,
the movability of the SDS-plus drilling tool can
lead to incorrect adjustment of the drilling depth.
– Pull the depth stop far enough out that the dis-
tance between the drill bit tip and the edge of
the depth stop corresponds to the required
drilling depth X.
Overload clutch
English
If the application tool jams or snags, the
u
power transmission to the drill spindle will
be interrupted. Always hold the power tool
firmly with both hands to withstand the
forces this may create and adopt a position
with stable footing.
Switch the power tool off immediately and
u
remove the application tool if the power tool
becomes blocked. Switching on when the
drilling tool is blocked may cause high
torque reactions.
Inserting screwdriver bits (see figure E)
Only apply the power tool to the screw/nut
u
when the tool is switched off. Rotating tool in-
serts can slip off.
A universal holder (16) with SDS-plus shank (ac-
cessory) is required to work with screwdriver bits.
– Clean and lightly grease the insertion end of the
shank.
– Insert the universal holder into the tool holder
while turning it until it locks automatically.
– Check that it is locked by pulling the universal
holder.
– Insert a screwdriver bit in the universal holder.
Only use screwdriver bits that fit the screw
head.
20 | English
– To remove the universal holder, slide the locking
sleeve (4) backwards and remove the universal
holder (16) from the tool holder.
Maintenance and Service
Maintenance and Cleaning
Remove the battery from the power tool be-
u
fore carrying out work on the power tool
(e.g. maintenance, changing tool, etc.). The
English
battery should also be removed for transport
and storage. There is risk of injury from unin-
tentionally pressing the on/off switch.
To ensure safe and efficient operation, al-
u
ways keep the power tool and the ventilation
slots clean.
Replace a damaged dust protection cap im-
u
mediately. It is recommended that you have
use an after-sales service for this.
– Clean the tool holder (2) after each use.
Customer service
Theo Förch GmbH & Co. KG
PQS
Theo-Förch-Str. 11-15
74196 Neuenstadt
reparatur@foerch.de
+ 49 7139 95 0
Transport
English
The recommended lithium-ion batteries are subject
to legislation on the transport of dangerous goods.
The user can transport the batteries by road
without further requirements.
When shipping by third parties (e.g.: by air trans-
English
port or forwarding agency), special requirements
on packaging and labelling must be observed. For
preparation of the item being shipped, consulting
an expert for hazardous material is required.
Dispatch battery packs only when the housing is
undamaged. Tape or mask off open contacts and
pack up the battery in such a manner that it cannot
move around in the packaging. Please also ob-
serve the possibility of more detailed national reg-
ulations.
English
English
English
1 609 92A 7MC • 28.11.22