Descargar Imprimir esta página

Metronic 477182 Manual De Instrucciones página 13

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 18
Full ring light.
Half ring light running from bottom to top.
Full ring speed up running
Full ring jump up and down
The last mode is turn off the light, press again to turn on light.
6.
Multiple volume control. Multiple volume selection. Press briefly to toggle between the
microphone input volume (H), echo amount (E), and output volume (V) levels indicated
from 0 to 30 on the front LED display. Turn the volume control knob to adjust each level.
7.
Microphone priority button. When activated, if the user speaks into the microphone, the
music stops automatically.
8.
Input mode button. Switches between all the input modes available. BT/USB/SD/AUX
modes available. The LED display indicates which mode has been selected.
9.
Main volume control. Use the master volume control to increase and decrease the
volume of your speaker. Press the multi-volume button to toggle between the microphone
volume and the amount of echo and adjust these values to your preference.
10. Microphone inputs x 2
11. AUX-IN input 3.5 mm. Note: The reset button is also located in this cavity. If the system
locks up, simply use a thin object such as a needle or paper clip to press this button to
reset the product.
12. USB/SD card input
Note: Maximum supported capacity of 32 GB for USB/SD card reading. MP3 music encoding
only.
13. Plug adapter 9V-1.5A (please only use the adapter provided with the speaker)
CHARGING
When heard low warning from the unit, please charge the battery at once. When the battery
is charging, the battery indicator on the top panel show in red, after full charge the indicator
show in green.
Note: If you experience any drop in volume during battery use, please put the speaker back
on mains power as this will be due to low battery.
BLUETOOTH CONNECTION
When the speaker is turned on, the speaker automatically switches to Bluetooth search mode,
Mobile phone open the Bluetooth and search "PARTYBTHPXLC", click on the connection.
A beep will sound to indicate that the speaker is connected to the device.
All connections are located at the top panel. The playback mode will automatically default
to the connected device. Disconnect the USB-SD card or the auxiliary cable to return to the
Bluetooth connection.
Make sure your storage media is in FAT 32 format.
MICROPHONE
Connect the microphone to the input on the top panel of the speaker and switch them on using
the slide switches. Adjust the microphone volume and echo using the multi-volume button
mentioned above.
Technical assistance : 02 47 346 392
13

Publicidad

loading