Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610957373 10-08:BM_2610957373 10-08.qxp 1/6/12 1:08 PM Page 11
4. Reload nails as described in the "Nail Loading" section of
this manual.
5. Reconnect air supply
Know what is behind your work piece.
WARNING
Do not fire nails into walls or floors
without assuring the area on the opposite side is clear.
A nail could travel through the work piece, striking someone.
Disconnect the tool from the air source
WARNING
before attempting to clear a jammed nail.
Such precautionary safety measures reduce the risk or
unintentional tool operation.
If a nail becomes jammed in the nosepiece, follow these
instructions to remove the jammed nail:
1. Release the trigger.
2. Disconnect the air supply from the tool.
3. Remove nails from the magazine as described in "Nail
Unloading."
4. Open the magazine latch. Pull the magazine away from
the housing until it slides off of the latch pin. This will
expose the jammed nail - FIG 17.
5. Remove the nail, using pliers if necessary.
6. If the driver blade is in the extended position, insert
screwdriver or other rod into nosepiece and push driver
blade into tool so that it is ready to fire - FIG 18.
7. Reattach the magazine as follows:
• First insure that the magazine latch is open. Then,
insert the latch pin into the largest opening in the
magazine bracket - FIG 19.
• Align the end of the magazine with nosepiece posts and
slide the magazine onto the tool, guiding the latch pin to
the end of the slot.
• Press the magazine latch back up to its locked position.
8. Reinsert nails into the magazine as described in "Nail
Loading".
9. Reconnect air supply as described in "Connecting Air
Supply".
NOTE: If nails continue to jam frequently in the nose piece,
contact BOSCH service center for repair.
Jam Clearing
Operation
FIG. 17
Magazine
FIG. 18
Driver
Blade
FIG. 19
11
Remove Nail
Latch
Screwdriver
Insert
Align with
Latch Pin
nosepece posts
Publicidad
