Publicidad
Idiomas disponibles
Idiomas disponibles
BM 2610957373 10-08:BM_2610957373 10-08.qxp 1/6/12 1:08 PM Page 9
The tool is equipped with a trigger that can select one of two
firing modes.
"Sequential" Firing Mode:
To use the tool to drive nails in this actuation mode, the
work contact element and trigger must be used in a specific
order:
1. Press and turn the selectable fire mode switch in the
downwards position. On the trigger, the firing mode
indicator should be pointing at the single nail icon - FIG 9.
2. The work contact element must be completely depressed
by placing the nose of the tool against the work piece -
FIG 10.
3. The trigger must be pulled firmly and then released - FIG
10.
4. The tool must be allowed to recoil away from the work
piece.
To continue operation in a separate location, move the tool
along the work piece, repeating steps 2 through 4 as
required.
"Bump" Firing Mode:
To use the tool to drive nails in this actuation mode the work
contact element and trigger can be actuated in any order.
1. Press and turn the selectable fire mode switch in the
upwards position. On the trigger the actuation mode
indicator should be pointing at the multi-nail icon - FIG 11.
2. Pull and hold the trigger with the tool off the work piece.
3. Press the work contact element against the work piece. A
nail will be driven - FIG 12.
4. The tool must be allowed to recoil away from the work
piece.
5. Move the tool along the work piece with a bouncing
motion. Each time the work contact element is depressed
a nail will be driven - FIG 12.
6. As soon as the desired number of nails has been driven,
remove finger from trigger.
Remove finger from the trigger when not
WARNING
driving nails. Always carry the tool by the
handle only. Removing your finger from the trigger when
not operating the tool reduces the risk of unintentionally
firing a nail and injuring yourself or someone else.
The tool must be allowed to recoil away from the work
piece. Do not drive a nail on top of
WARNING
another nail. If the tool is not moved before
the trigger is pulled again a second nail will be driven on top
of the previously driven nail. This could cause the nail to be
deflected or the tool to react in an unexpected manner.
Firing Modes
Operation
Sequential Fire Position
FIG. 9
FIG. 10
Selectable Fire
Mode Switch
FIG. 11
FIG. 12
9
Press
then turn
Selectable
Fire Mode
Switch
Trigger
Press
then turn
Bump Fire
Position
Publicidad
