Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION AND SET UP FOR HOMEAWARE™
Placement of the Doorbell Transmitter
Proper placement of the HomeAware™ doorbell transmitter is important because it uses Digital RF
frequencies to send its signal. It's important to not place or install it on anything made of metal because
RF signals cannot transmit through anything made of metal.
Installation and Set Up of Doorbell Transmitter
Note: There are two methods to install/set up the doorbell transmitter, both require batteries
1.
Stand-alone no chime box. With this method no existing doorbell chime box is available. Placement
of the transmitter must be within 50ft of the HomeAware™ Main unit (See Step 1 for doorbell
transmitter set up below).
2.
To existing chime box. This is the preferred method as it keeps the transmitter out of the elements
and in closer range to the main unit (See step 2 for doorbell transmitter to existing chime box set up
below).
Please determine which method you will use and continue with the following installation directions.
Step 1) Installation with No Existing Doorbell Chime Box
For this method you will need the provided connector wire to install. We provide screws, and a mounting
block (see diagram for transmitter installation on next page), also see step by step instructions.
To install to a hard surface using the provided hardware follow these steps:
a) Install mounting block using provided short screw. Install the small side to the surface (side without
arrow). This will provide a space for the unit to slide over in order to attach to the mounting block.
b) Remove the screw cover at the top of the doorbell unit, the cover has the Sonic Alert logo on it; this
will slide up to remove. Once removed, you'll see the top screw mounting hole.
c) Once the mounting block is in place, and you have removed the top screw cover, position the back of
the doorbell transmitter over the mounting block. There is a square opening that the block will fit into
see below. Position that opening over the mounting block. Next slide the doorbell unit down on the
block about 1/8 inch and install the top screw. The doorbell unit should stay on by itself if installed
correctly. If not then you may have the block mounted upside down, try reversing it.
HA360DB – Doorbell Transmitter Continued
2
Publicidad
