Onkyo NS-6170 Manual De Instrucciones página 17

> Before Start > Part Names
Listening to the FM Radio
1
a
b
c
d
16
> Install > Initial Setup
e
f
g
h
> Playback
Advanced Setup | Firmware Update | Others
Tuning Automatically
1. Turn the unit on.
2. Repeatedly press TUNER to switch input to FM.
i
3. When you press 22/11 (b) on the remote controller,
automatic tuning starts, and searching stops when a
station is found. "FM ST" indicator on the display lights
when FM stereo station is being received.
When FM broadcasts are difficult to receive : Perform the
procedure for "Tuning Manually". If you tune manually, the
reception for FM broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the reception.
Tuning Manually
1. Turn the unit on.
2. Repeatedly press TUNER to switch input to FM.
3. Press TUNING MODE (h) on the remote controller or
MENU/ENTER dial on the main unit so that the "AUTO"
indicator on the display goes off.
4. Select the station you want to listen to while pressing
22/11 (b) on the remote controller.
0 The frequency changes by 1 step each time you press
the button. The frequency changes continuously if the
button is held down and stops when the button is
released. Tune by looking at the display.
Registering a station
You can register a maximum of 40 stations.
1. Tune into the radio station you want to register.
2. Press MEMORY (d) on the remote controller so that the
preset number on the display flashes.
FM 87 . 50MHz
FM 87 . 50MHz 1
E
N