Publicidad
Idiomas disponibles
Idiomas disponibles
> Before Start
> Part Names
Network
∫ Connection
Select the type connection to the network.
Select the item with
/
on the remote controller and press ENTER.
"Wi-Fi": To connect via wireless LAN
"Wired" (Default Value): To connect via wired LAN
Perform "Wi-Fi Setup" if you select "Wi-Fi".
∫ Wi-Fi Setup
Make Wi-Fi connection settings. (
This can be set only when "Wi-Fi" is selected in "Connection".
0 You can make Wi-Fi connection settings using a web browser on a computer. For details,
refer to "Web Setup" (
P26).
∫ DHCP
Select the item with
/
on the remote controller and press ENTER .
"On" (Default Value): Auto configuration by DHCP
"Off": Manual configuration without DHCP
If selecting "Off", you must set "IP Address", "Subnet Mask", "Gateway", and "DNS"
manually.
∫ IP Address
Displays/Sets the IP address.
∫ Subnet Mask
Displays/Sets the subnet mask.
∫ Gateway
Displays/Sets the gateway.
∫ DNS
Displays/Sets the primary DNS server.
∫ Proxy URL
Displays/Sets the proxy server URL.
24
> Install
P10)
> Initial Setup
> Playback
∫ Proxy Port
Displays/Sets the proxy server port number when you enter "Proxy URL".
∫ Friendly Name
Change the device name for this unit which is shown on other devices connected to the
network to an easily recognized name. You can input up to 31 characters. For details on how
to enter text, refer to "Entering text" (
∫ AirPlay PW
You can set a password of up to 31 characters so that only registered users can use AirPlay.
For details on how to enter text, refer to "Entering text" (
∫ Network Check
You can check the network connection. The confirmation results are displayed when you
press ENTER.
Option
∫ PWR Setting
Auto Standby
NET Stby
Advanced Setup
P22).
P22).
This setting places the unit on standby automatically after 20
minutes of inactivity without any audio input.
"On" (Default Value): The unit will automatically enter standby
mode.
"Off ": The unit will not automatically enter standby mode.
When this feature is turned "On", you can turn on the power of the
unit via the network using an application that can control this unit.
Select the item with
/
on the remote controller and press
ENTER.
0 Setting to "On" (Default Value) increases the power
consumption even when the unit is on standby.
0 "NET Stby", which suppresses power consumption, may be
disabled when the network connection is lost.
| Firmware Update | Others
E
N
Publicidad
