Publicidad
Idiomas disponibles
Idiomas disponibles
1. ON/OFF
* Press this button to turn on/off the unit.
* This will clear the existing timer and SLEEP settings.
2. /
* Press this button to set the temperature display to Fahrenheit, which is displayed by
default in Celsius. The " " will not be displayed on the LCD.
* Press this button again to restore the temperature display to Celsius.
Note: Temperature display in Fahrenheit is not available for some models. When
temperature is displayed in Fahrenheit on the remote controller, it might be in Celsius
on the unit, the function and operation of which will not be affected.
3. SPEED
* Press this button, you can select the fan speed as follows:
Low → Mid → High → Auto
Note: AUTO air speed is not available in FAN mode.
4. DISPLAY
* Press this button to turn on/off the display. This is for the convenience of users who
are unconformable sleeping with the backlight on.
5. iFEEL
* Press this button to set the temperature display on the remote controller to ambient
temperature and press this button again to set it to preset temperature.
6. TIMER
* With the unit ON, press this button to set OFF timer or with it OFF to set ON timer.
* Press this button once, a "ON(OFF)" will flash. Press "▲"or " ▼" to set the number
of hours in which the unit will be turned ON/OFF, with an interval of 0.5 hour if less
than 10 hours, or 1 hour if longer than 10 hours and a range of 0.5-24 hours.
* Press it again to confirm the setting the "ON (OFF)" will stop flashing.
* If the timer button is not pressed longer than 10 seconds after the "ON (OFF)" start
flashing, the timer setting will be exited.
* If a timer setting is confirmed, pressing this button again will cancel it.
Note: When a ON timer is set, all function buttons (except SLEEP DISPLAY and
iFEEL can't be set ) are valid and when the ON time set is up, the unit will operate as
preset.
123
Publicidad
