Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
6.
Preparation
6.1
•
Open the cap 10 and fill the cold water tank with tap water.
•
Connect the plug to a socket on a patchboard provided with a switch with an efficient earth
connection.
The appliance is provided with a power cord according to its electrical input
characteristics. It's important to verify that the electrical mains are according to the
norms. It is recommended that the power supply of this appliance includes a differential
switch of 30 mA maximum.
Starting of machine
6.2
•
Switch on the main switch (1) to start the machine.
•
The indicator light (4) goes on.
•
When the pump has filled up the boiler and stops,
the machine starts heating up (about 6 minutes).
•
When the indicator light 7 goes on the appliance is
ready for use.
•
Connect the steam hose to the socket 2, making sure
that it is inserted correctly.
•
Push the steam button on the handle and direct the
steam jet towards the area which has to be cleaned.
•
To start the detergent function, push the switch (12)
on the control panel and the switch (14) on the
handle of the lance
Before starting steam cleaning, blow off the initial condensation in the conducts in a
bucket or any other suitable place.
Refilling water
6.3
When the water tank is empty, you will hear an acoustic signal and the indicator light 6 will go on. No
steam comes out anymore.
Proceed as follows:
•
Open the cap 10 and fill water in the tank.
•
Close the cap 10
•
After a few seconds the indicator light 7 will go on, and you can continue cleaning.
Maintenance
7.
Always unplug the appliance before cleaning or servicing operations on the machine.
For the safety of the operator and to secure always perfect performances, the following controls and
servicing is recommended:
- Check regularly that the power cord does not present any signs of wear or ageing. If it is
damaged, it is absolutely necessary to replaced it immediately by the same type of power cord,
12
Publicidad
Tabla de contenido
