Installation
instructions
Before you begin
R
ead these instructions completely
and carefully.
I
mportant -
Save these instructions for local
inspector's use.
I
mportant -
Observe all governing codes and
ordinances.
N
ote to installer - Be sure to leave these
instructions with the customer.
N
ote to customer - Keep these instructions
with you for future reference.
I
f appliance is removed from service or
discarded, remove the washer and dryer doors.
I
nspect the exhaust outlet of the dryer and set
connection to wall outlets if they are tilted.
S
ervice information and the wiring diagram are
located on the access panel.
D
o not allow children on or in the appliance.
W
hen the appliance is used near children, it is
necessary to supervise them closely.
I
nstall the appliance where the temperature is
above 10°C, for satisfactory operation of the
dryer control system.
• The appliance is not be used by children under the age of 8 years.
T
•
his appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved.
C
•
hildren shall not play with the appliance.
C
•
leaning and user maintenance shall not be made by children without supervision.
C
•
hildren of less than 3 years should be kept away unless continuously supervised.
Tools you
will need:
S
lip Pliers
P
S
hillips
crewdriver
F
S
lat-blade
crewdriver
N
D
1/4"
ut
river
L
evel
modelos:
MCL1540EEBBY,
MCL1540EEDGY,
ECL1540EEBBY,
ECL1540EEDGY,
Warning
T
o reduce the risk of injury or death, follow all installation instructions.
T
he
I
nstall the appliance according to these instructions and in accordance with
local codes.
T
his appliance must be have an exhaust leading to the outdoors.
U
se only a 4" rigid metal duct for the appliance´s exhaust leading to the
outdoors.
DO NOT
metal (semi-rigid or foil-type) duct is installed, it must comply with local safety
standards and be installed according to the instructions found under
"Connecting the Dryer to House Vent" on page 19 of this manual. Flexible
ventilation materials are known to collapse, be easily crushed, and trap lint.
T
hese
D
o not install or store this appliance in any location where it could be exposed
to water and/or weather.
K
eep these instructions. (Installers: Be sure to leave these instructions with the
customer).
Note:
mechanical and electrical skills. It is your responsibility to have
Materials you will need:
4" diameter
metal duct
(Recommended)
4" duct
clamps (x2)
or 4 spring
clamps (x2)
T
ransition duct (if
(semi-rigid) metal, kit
T
ransition duct
4"
(if needed) in
plate (if
needed) (kit)
(4" aluminum-type sheet)
Electric
MCL2040EEBBY,
MCL2040EEDGY,
Laundry Center
MKTG15GNAWB
Risk of Fire
I
nstallation and service of this appliance requires basic
4" diameter
metal elbow
D
uct tape
H
G
loves
3/4"
C
S
over
t
S
afety
glasses
12
I
dentify the type of cable as per the
house receptacle before purchasing the
power cord.
S
ince
by rigid tube.
ood
i a r
r n
l e
f e i
234D1335P009