Tripp-Lite TLP606USB Manual Del Propietário página 2

Important Safety Instructions
SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension
cords or adapters. This surge suppressor is designed for indoor use only. Install the surge
suppressor away from heat-emitting appliances such as radiators or heat registers. Do not
install where excessive moisture is present. Do not plug extension cords into it. Never install
electrical, telephone, network or coaxial wiring during a lightning storm. Do not drill into any
part of the housing or open the housing for any reason. There are no user-serviceable parts
inside.
• Use of this equipment in life support applications where failure of this equipment can
reasonably be expected to cause the failure of the life support equipment or to significantly
affect its safety or effectiveness is not recommended. Do not use this equipment in the
presence of a flammable anesthetic mixture with air, oxygen or nitrous oxide.
Installation
Mount Your Surge Suppressor
(Optional Installation, TLP606USB Only): If desired, mount your surge suppressor on a
wall or other sturdy, vertical surface. However, you must mount the surge suppressor prior to
connecting your equipment. Place a sheet of paper over the surge suppressor's mounting
holes and mark their centers with a push pin. Next, place this template over the desired
area and mark with the push pins. Install screws (user supplied) into the marks until ¼ in.
(0.6 cm) of the screw heads are exposed. Mount the surge suppressor over the screw
heads and slide into place.
(Installation, TLP606DMUSB
Only): This suppressor features
a built-in clamping system for
attaching the unit to desks,
tables and work benches. To
install, loosen the two mounting
clamps, then slide the
suppressor firmly onto the edge
of an appropriate surface.
Retighten the mounting clamps.
Connect Your Surge Suppressor
to the AC Power Line: Plug the
surge suppressor's power cord into a
standard, 3-wire grounded 120V AC
outlet.
Turn Your Surge Suppressor ON:
Press the surge suppressor's power
switch to "ON" or "RESET"
(depending on model). Select
models feature an illuminated switch.
Installation, TLP606DMUSB Only
2