Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION - Ventilate
1. Set the fan on a level surface, such as a table.
2. Tilt the fan to the required angle (see figure 3). You can set the
fan:
a. to blow horizontally (position a) or angled slightly downwards
(position b). Tilt the ventilator housing and motor housing to
the required angle.
b. to oscillate from left to right (with a sweep of 90 °). This will
ventilate much of the room. Press the oscillation button on
the motor housing fully in.
c. remain in the same position whilst the fan is turning. This will
ventilate one area. Pull out the oscillation button until you
hear it click.
3. Put the plug into the wall socket.
4. Start the fan by selecting one of the three speed settings.
a. Position "1", the fan runs slowly.
b. Position "2", the fan runs normally.
c. Position "3", the fan runs quickly.
5. Stop the fan by switching to position "0".
CLEANING AND MAINTENANCE
Over time, dust can accumulate in the fan basket and on the fan blades. Always begin by trying to remove
the dust with a brush and/or vacuum cleaner. If this does not remove all the dust you can always dismantle
the fan and clean it.
1. Remove the plug from the wall socket.
2. Loosen the bolt in the rim around the fan housing using a small crosshead screwdriver.
3. Remove the rim and the front half of the filter housing.
4. Hold the fan blades to stop them from turning, and unscrew the spinner by turning clockwise in the
direction of the 'LOOSEN' arrow. Remove the fan blades from the motor housing.
5. Remove the rear half of the fan housing by turning the locking ring at the centre of the housing
anticlockwise. Remove the ring and the housing from the motor housing.
6. Clean the dismantled parts and the base with a damp cloth. Dry thoroughly with a dry cloth.
7. Clean the motor housing with a dry cloth.
WARNING:
•
Verify that the appliance is not connected to the power supply before you clean it.
•
Never use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes) to
clean the appliance.
Reassemble the fan using the procedure given under by 'Assembling the fan'.
b
25
a
EN
Publicidad
