Philips GC7035 Manual Del Usuario página 6

ENGLISH
8
9 If necessary, you can repeat steps 1 to 8. Make sure that you empty the Calc-
Clean container before you start the Calc-Clean process.
Note: During the Calc-Clean process, clean water may come out of the soleplate
if no scale has accumulated inside the iron. This is normal.
For more information on how to carry out the Calc-Clean process, refer to the videos
in this link: http:/ /www.philips.com/descaling-iron.
Energy saving
Eco mode
By using the ECO mode (reduced amount of steam), you can save energy without
compromising on the ironing result.
1 To activate the ECO mode, press the ECO button. The green ECO light goes
on. (Fig. 16)
2 To deactivate the ECO mode, press the ECO button again. The green light goes
off.
For the best results on tough fabrics you can use the TURBO mode.
1 Press and hold the on/off button for 2 seconds until the light turns white.
2 To deactivate the TURBO mode, press and hold the on/off button for 2 seconds
again until the light turns blue.
Safety auto-off (specific types only)
The safety auto-off function automatically switches off the appliance if it has not
been used for 5 minutes, to save energy.
Troubleshooting
This chapter summarises the most common problems you could encounter with the
appliance. If you are unable to solve the problem with the information below, visit
www.philips.com/support for a list of frequently asked questions or contact the
Consumer Care Centre in your country.
Problem Possible cause
The iron does There is not enough
not produce any water in the water tank.
steam.
You have not pressed
the steam trigger.
The steam function has
been disabled until you
have performed the
Calc-Clean process.
The light of the This is the Calc-Clean
Calc-Clean reminder.
button flashes
and/or the
appliance beeps.
Solution
Fill the water tank beyond the MIN
indication. Press and hold the
steam trigger until steam comes
out. It may take up to 30 seconds
until steam comes out.
Press and hold the steam trigger
until steam comes out.
Perform the calc-clean process to
restore the steam function (see
chapter 'IMPORTANT - Cleaning
and maintenance').
Perform the Calc-Clean process
within 1 hour after the Calc-Clean
reminder is given (see chapter
'IMPORTANT - Cleaning and
maintenance').