Philips GC7035 Manual Del Usuario página 7

Problem Possible cause
The light of the You have not done or
Calc-Clean have not completed the
button flashes Calc-Clean process.
and the
appliance beeps
every time I
press the steam
trigger. No steam
comes out of the
soleplate.
The appliance The safety auto-off
has switched off. function was activated.
This happens
automatically when the
steam generator has not
been used for more than
5 minutes.
The appliance The water tank is empty.
produces a loud
pumping sound.
Water droplets After the Calc-Clean
come out of the process, remaining water
soleplate. may drip out of the
soleplate.
The Calc-Clean process
has not been completed.
Dirty water and Impurities or chemicals
impurities come present in the water have
out of the deposited in the steam
soleplate. vents and/or soleplate.
Water flushes You have accidentally
out of the started the Calc-Clean
soleplate. process (see chapter
'IMPORTANT - Cleaning
and maintenance').
The Calc-Clean You have not pressed
process does not the Calc-Clean button for
start. 2 seconds until the
appliance started
beeping.
Solution
Perform the Calc-Clean process to
enable the steam function again
(see chapter 'IMPORTANT -
Cleaning and maintenance').
Set the on/off switch to 'off'
position and then to 'on' position.
Fill the water tank with water and
press the steam trigger until the
pumping sound becomes softer
and steam comes out of the
soleplate.
Wipe the soleplate dry with a piece
of cloth. If the light in the Calc-
Clean button still flashes and the
appliance still beeps, perform the
Calc-Clean process (see chapter
'IMPORTANT - Cleaning and
maintenance').
You have to perform the Calc-
Clean process again (see chapter
'IMPORTANT - Cleaning and
maintenance').
Perform the Calc-Clean process
regularly (see chapter 'IMPORTANT
- Cleaning and maintenance').
Switch off the appliance. Then
switch it back on again. Let the iron
heat up until the 'iron ready' light
lights up steadily.
See chapter 'IMPORTANT -
Cleaning and maintenance' .
ENGLISH
9