Philips HR7978 Manual Del Usuario página 8

For ice crushing, turn the knob to speed P
repeatedly until the ice is finely crushed.
Note
•
Never open the lid to put your hand or any object in
the jar while the blender is running.
•
Always assemble the sealing ring onto the blade unit
before you attach the blade unit to the blender jar.
•
To add liquid ingredients during blending, pour them
into the blender jar through the feeding hole by
removing the measuring cup.
•
Precut ingredients into small pieces before you process
them.
•
If you want to prepare a large quantity, process small
batches of ingredients instead of a large quantity at
once.
•
To avoid spillage: When you process a liquid tends to
foam (for example, milk), do not put more than 1 liter
of liquid in the blender jar.
•
Put the ingredients in the blender jar within the
maximum level indication.
•
To achieve the best result when blending thick puree,
fill the blender jar half full and process the ingredients in
separate blending batches.
Food processor (HR7954/
HR7958/HR7974/HR7978
only)
Blade unit
Before you start, make sure that you assemble
according to Fig. 4.
Blade unit: for chopping, mixing and pureeing
ingredients
To remove the food that sticks to the blade or
bowl wall, stop processing and switch off the
appliance first, and then use a spatula.
14 EN
Note
•
Always put the blade unit in the bowl before you start
to add the ingredients.
•
Do not use the blade unit to chop hard ingredients, like
coffee beans, turmeric, nutmeg, and ice cubes, as this
may cause the blade to get blunt.
•
Do not let the appliance run too long when you chop
(hard) cheese or chocolate. Otherwise these ingredients
become too hot, start to melt, and turn lumpy.
Disc with inserts
Before you start, make sure you pick your
desired insert from following and assemble
according to Fig. 5.
Name
Granulating
insert
Slicing insert
Shredding
insert
Caution
•
Be careful when you handle the slicing blade of disc
insert. It has a very sharp cutting edge.
•
Never use the disc insert to process hard ingredients,
like ice cubes.
•
Do not exert too much pressure on the pusher when
you press ingredients into the feed tube.
Note
•
Precut large ingredients into chunks that fit in the
feeding tube.
Follow the steps below to assemble the disc
inserts (Step 1 in Fig. 5).
1
Place the opening of the insert over the
shaft of the insert holder.
2
Push the opening of the insert over the
projection on the shaft.
Purpose
For granulating
ingredients to
small/fine pieces
For slicing
ingredients
For shredding
ingredients into
small strips