Publicidad
Idiomas disponibles
Idiomas disponibles
WATER DISCHARGE
The unit is equipped with an evaporation system. Liquefied water is used to cool the
condenser, which increases the cooling efficiency and reduces energy consumption.
If the amount of water in the system reaches the maximum level, the „WATER FULL"
indicator on the control panel lights up, and the compressor stops working.
Manual removal of water
Switch off the device and move it to a place where water can be drained from it.
Remove the plug from the hole „13" and carefully drain the water.
Insert the plug into the hole „13".
Turn the device on again.
Constant water drainage drawing 6.
Turn the appliance off.
Remove the plug from the hole „10".
Mount the rubber tube (not included) and place its other end in a container, e.g. a bucket.
MAINTENANCE
Note: Turn off the unit and unplug it before any maintenance or repair begins to avoid
electric shock.
CLEANING
Unplug the unit before any cleaning.
Clean the housing with a soft moisture cloth. Do not use chemical solvent (such as benzene,
alcohol, gasoline). The surface may be damaged or even the whole case may be deformed.
Do not sprinkle water on the unit.
AIR FILTER - drawing 7.
Clean the air filter every 2 weeks. If the air filter is blocked with dust, the efficiency will
reduce.
Open the air filter cover upwards, and then take out the air filter.
Wash the air filter by immersing it gently into warm (about 40
detergent, rinse it and dry it thoroughly in a shaded place.
END OF SEASON
·
Please drain the water.
·
Keep the unit running in "Fan" mode for two hours until the inside of the unit is dry.
·
Turn off the unit and unplug it.
·
Clean the air filter and after dry it thoroughly, reinstall it.
·
Remove the exhaust pipes and keep them carefully.
·
Wrap the unit with the plastic bag and keep it in a dry place.
C) water with a neutral
o
EN
•
23
Publicidad
