Allmatic CENTRALINA BAX900 HR Manual De Instalación página 12

6. Learnings
6.1 Learning a transmitter through the "RADIO LEARN" key of the control unit
"UP" Button
6.1.1 Learning of a two buttons transmitter
STOP THE
AUTOMATION
Press and release the UP button of the transmitter. The
buzzer emits a short beep.
Wait few seconds for the automatic learning of the DOWN
button. Otherwise press and release the DOWN button of
the transmitter. The buzzer emits a short beep followed by
two long and two short beeps.
6.1.2 Learning of a four buttons transmitter
In case of using a four buttons transmitters to command two automations, pay attention that the two buttons that move the automation are horizontal
not vertical.
First automation
Second automation
6-1622604 rev.0 10/03/2016
"DOWN" Button
Press and release the RADIO LEARN
button. The buzzer emits long beeps each
second
SI
SI
SI
The 2 buttons are learnt and the
procedure finishes. Repeat
procedure if you wish to learn a new
transmitter.
ITA
Check that the automation is still.
NO
If the buzzer emits a long beep and two short ones, the
NO
transmitter was already been memorized. If the buzzer
does not make any signal verify that the transmitter
works and belongs to the HR Series.
If the buzzer does not emit any signal, repeat the
NO
procedure with another transmitter.
the
ENG FRA ESP DEU POR
The control unit is compatible only
with HR Rolling Code transmitters
4 / 8