TECshow HALO 80 LED Manual De Usuario página 7

System Error
DMX Monitor
Error
MT board connection failed
Pan Reset failed
Tilt Reset failed
Pan Hall failed
Tilt Hall failed
Color Wheel Reset failed
Gobo Wheel Reset failed
Focus Reset failed
DMX Channel Table
CH
1
2
3
4
5
6
7
8
Panwheel Step
Tiltwheel Step
(See common mistakes Rear)
The driver board did not respond. Serial communication line connect-
ing display panel and driver board.
There is a problem, or there is a problem with the driver board.
X-axis photoelectric switch, or problem with X-axis motor
Y-axis photoelectric switch, or problem with Y-axis motor
Pan Hall have problem
Tilt Hall have problem
Color Wheel Hall , or Color Wheel motor have problem
Gobo Wheel Hall , or Gobo Wheel motor have problem
Focus Hall , or Focus motor have problem
16CH
Pan
Pan Fine
Tilt
Tilt Fine
Dimmer
Strobe/Shutter
Color Wheel
Gobo Wheel
When walking in the positive direction, the
step value should increase, when going back,
The step value should be reduced. The value
is the same every time you go to a certain
point.
If the red ERR indicator is lit, the luminaire is
running.
An error can be made by going to the sub-in-
terface for details.
After viewing, you can press the "Clear" but-
ton to clear the error record.
This enters the sub-interface and displays
the channel values as values for viewing.
Description
Channel Mode
Pan Fine
Tilt Fine
Dimmer
Strobe/Shutter
Color Wheel
Gobo Wheel
20CH
Pan
Tilt
- Tecshow Halo 80 LED
English Version
P. 7