Publicidad
Idiomas disponibles
Idiomas disponibles
SKETCH AND DIMENSIONS
OPERATION
● Connect the bed to an electrical outlet using the power
cord.
Hand controller
1
2
3
4
5
6
7
8
9
10
11
- Press the button
to activate the control knob. The
1
red indicator will light up and all its functions can be
used.
- Press the button
again and the red indicator will
1
turn off at the same time as the bed remains flat and
in the lowest position possible.
- Press the buttons
7
–
the 3 factory-stored positions.
- Press the button
and the heating will start at
10
normal level. The indicator will light up green. Press
the button
again and the heating will stop. The
10
green indicator will turn off.
-
Press the button
and the heating will start at high
11
level. The indicator will light up red. Press the button
again and the heating will stop. The red indicator
11
will turn off.
- Set any of the 3 factory-stored positions to a new
position:
• Once the bed is in the desired position, press the
9
to place the bed in one of
SET button until the blue indicator lights up.
•
While the blue indicator is lit, press one of the
three buttons (P1, P2, P3) for where you want to
memorise the new position.
• The new position will be memorised in the selected
button.
● Adjusting height and tilt
2
2
- Use the buttons
and
2
adjust the height and/or tilt of the bed, moving the
motors inside each column independently.
● Adjusting backrest tilt
- Use the buttons
4
on the control knob to adjust the
tilt of the backrest.
● Adjusting footrest tilt
3
3
on the control knob to
3
3
Publicidad
