Descargar Imprimir esta página

Genie TL48 Manual Del Usuario página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 10
• The lamp must not be opened, any repairs may only be carried out by trained electricians.
• For cleaning only use a dry and soft cloth, no detergents and chemicals.
• When not in use for a long time, charge the battery every 3 months to maintain the capacity.
• The bulb cannot be replaced.
Delivery
• LED desk lamp
• USB charging cable
• Operating manual
Technical specifications
See page 21
Initial commissioning / Charging
• Compare product and USB power source specifications as they must be identical.
• Use only the supplied USB charging cable.
• Before initial operation, the battery must be fully charged. Depending on the USB power source
used, this can take up to 6 hours.
1. Insert the 3.5 mm jack plug of the supplied charging cable into the 3.5 mm jack socket of the
LED desk lamp.
2. Connect the USB 2.0 port of the charging cable to a USB power source. This can either be a
220/230 V USB charging adapter or the USB port of a PC.
3. The red indicator lights up during charging and goes off when the battery is fully charged.
4. When the battery is charged, disconnect the charging cable from the LED desk lamp and from
the USB power source.
5. The lamp should be recharged at the latest when it starts to dim, or it cannot be turned on.
On / Off Switch
Place the lamp on a level and non-slip surface, slide the power switch to the ON position, the
lamp is now on.
Briefly touch the sensor button "
" to switch the light on / off.
Set the light color
Briefly touch the "
" to change the light color from warm-white 3000K in 3 levels to cold-white
6500K.
When the lamp is switched on again, the last setting is accepted.
Brightness adjustment
When the lamp lights up touch and hold the sensor button "
" until the desired brightness is
reached.
When the lamp is lit touch the sensor button "
" or "
" until the desired brightness is reached.
Timer function
Touch and hold the "
" button to start the countdown function. When the light flashes twice, the
timer function starts. After 40 minutes, the light goes off automatically. If the "
" is touched
again, the 40 minute countdown starts again.
6

Publicidad

loading